Need help? Call us on 01494 461711
Delivery on Tuesday

order in 188980 seconds

Free delivery & toolkit

on orders over £250 ex VAT

20 year warranty
Life expectancy

free downloadable warranty

Secure payments

safe and secure online

Visit our old website

How to Install a Firestone Rubber Roof

Everything you need to know to install your rubber roof

Step-by-Step Installation of Firestone RubberCover EPDM

The adhesives are not designed to be used or stored in freezing conditions (or if freezing conditions are due within 24 hours) as it may affect their performance. A heated room below, or covering over with a tarpaulin is often sufficient to prevent the glues from freezing.

We also have a range of installation videos available in our video tutorials section.

1. Firestone Rubbercover installation Step 1

Strip off the existing roof back to bare decking or overboard with new ply or OSB.

2. Firestone Rubbercover installation Step 2

Remove arris rails from any open edges and fit 2" × 1" timber batten to perimeter.

3. Firestone Rubbercover installation Step 3

Lay rubber in the correct position and allow to relax for 20 minutes.

4. Firestone Rubbercover installation Step 4

Fold one half of the membrane back and after stirring, apply water based adhesive to the deck. Repeat to other half of roof. Sweep out any air bubbles.

5. Firestone Rubbercover installation Step 5

Using either our spray or brush applied contact adhesive, apply thinly to both rubber and upstand.

6. Firestone Rubbercover installation Step 6

Use primer and 9" flashing tape to seal where the roof abuts the building.

7. Firestone Rubbercover installation Step 7

Fix RubbaTrim to the roof perimeter c/w matching corners and joiners using the colour coded polynails.

8. Firestone Rubbercover installation Step 8

Install wall trim to rear.

Rubba-seal support staff, child with hammer

Looking for help or advice?

Our highly experienced team have been there, done it and bought the hard hat. If you're in need of any help or advice, please don't hesitate to contact us by emailing info@rubba-seal.co.uk or phoning 01494 461711. We would be more than happy to help with any questions you may have.

Get in touch

© 2019 Avenir Roofing Ltd  •  All rights reserved
Registered in England and Wales: 04710777  •  
VAT registration number: 527 2382 48

Web design & development by Fifty Digital Logo