There are 0 items in your cart |
order in 6510 seconds
on orders over £250 ex VAT
free downloadable warranty
Encrypted With SSL
Step by step guide on installing wall-trim flashing to your next EPDM Roofing project.
Download PDF
Thoroughly clean the wall, chase and rubber.
Apply a thin coat of contact adhesive to the rubber and the wall .
Shop EPDM Adhesives
Once touch dry, starting at the bottom, carefully mate the surfaces together. Smooth by hand and silicone roller.
Trim membrane.
Position a piece of 9” QuickSeam Formflash or a Detail Kit as shown and mark the perimeter, allowing an extra 1 cm.
Shop Flashings & Seam Tapes
Apply Quick Prime plus to the marked area using a Quick Scrubber pad and handle, allow primer to dry.
Peel back a section of backing paper and, starting from the top, slowly work downwards as shown.
Apply a gentle heat source to the corner if needed.
Thoroughly roller with Silicone and Penny Rollers.
Insert wall trim into chase and secure at 600mm centres with the supplied fixings. Rawplugs are not needed if a 5.5mm masonry drill bit is used.
Thoroughly seal chase with Wall Mastic.
Click on our friendly RoofBot to help you work out what you need for your DIY Firestone RubberCover project, just input your dimensions, answer some simple questions and let RoofBot do the rest. If you still need assistance, don't hesitate to contact us on LiveChat, info@rubba-seal.co.uk or 01494 461711.
© 2021 Avenir Roofing Ltd t/a Rubba-Seal • All rights reserved
Registered in England and Wales: 04710777 •
VAT registration number: 527 2382 48
Web design & development by 
